Back to Contents Page

Speakers

Dell™ Latitude™ D510 Service Manual

CAUTION: Before performing the following procedures, read the safety instructions in your Product Information Guide.

NOTICE: To prevent damage to components inside your computer, discharge static electricity from your body before you touch any of your computer's electronic components. You can do so by touching an unpainted metal surface.

1. Follow the instructions in "Preparing to Work Inside Your Computer."
   
   
2. Remove the palm rest.
   
   
3. Note the location of the coin-cell battery.
   
   
4. Remove the speaker cable from the speaker-cable routing clips.
   
   

NOTICE: To avoid damage to the speaker cable, be sure to re-route it through both securing clips. When inserting it back into each routing clip, slightly bend open the clip with your finger, insert the cable, and then press the clip closed.

5. Disconnect the speaker connector from the system board connector.
   
   

NOTICE: Handle the speakers with care to avoid damaging them.

6. Remove the M2.5 x 5-mm screw labeled "B" from the speakers.
   
   
7. Gently pull the front of the computer base outward while lifting the speakers.
   
   

1	speaker connector
2	M2.5 x 5-mm screw labeled "B"
3	coin-cell battery
4	coin-cell battery compartment
5	speakers
6	computer base

8. Disconnect the coin-cell battery from the speakers.
   
   

NOTICE: When replacing the speakers, be sure to replace the coin-cell battery in its compartment.

Back to Contents Page