13.3-Inch Display Assembly: Dell Latitude CP and CPi
13.3-Inch Display Assembly: Dell™ Latitude™ CP and CPi
Removing the Display
Assembly | Exploded View of
Components | Field-Replaceable
Components
To remove the display assembly, follow these steps:
- Remove the palmrest assembly.
- Remove the (2) 5-mm interface-cable grounding screws from
the display-assembly interface cable.
- Disconnect the display-assembly interface cable from
connector JP1 on the system board by grasping the
grounding tabs and pulling the connector straight up from
the system board.
- Close the display, being careful not to damage the
display interface cable.
- Remove the 4 silver 5-mm screws securing each of the 2
hinge brackets to the bottom case assembly.
- Lift the display assembly from the bottom case assembly.
 |
NOTE: When reinstalling the display
assembly, install the 4 screws securing the hinges at the
locations marked by arrows on the face of each hinge. |
 |
CAUTION: When reinstalling the
interface-cable connector, be very careful not to insert
the connector at an angle. Position the cable end over
the connector and push the connector straight down to
prevent bending the connector pins. |
The display assembly consists of the following
field-replaceable components:
|
