Back to Contents Page

Palm Rest

Dell™ Latitude™ X300 Service Manual

  Removing the Palm Rest

  Replacing the Palm Rest

Removing the Palm Rest

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the System Information Guide.

NOTICE: Disconnect the computer and any attached devices from electrical outlets.

NOTICE: To avoid ESD, ground yourself by using a wrist grounding strap or by touching an unpainted metal surface on the computer.

NOTICE: Read "Before You Begin" before performing the following procedure.

1. Remove the battery.
   
   
2. Remove the keyboard.
   
   
3. Turn the computer over, and remove the three M2 x 4-mm screws from the bottom of the computer.
   
   

1

M2 x 4-mm screws (3)

98MKC

4. Turn the computer over, and open the display.
   
   
5. Remove the six M2 x 4-mm screws on the palm rest.
   
   

1

M2 x 4-mm screws (6)

98MKC

6. Lift up and rotate the palm rest forward.
   
   
7. Lift the ZIF connector, and disconnect the palm-rest flex cable from its ZIF connector on the system board.
   
   

1	palm-rest flex cable
2	ZIF connector
3	palm rest

8. Lift the palm rest up and out of the computer.
   
   

Replacing the Palm Rest

To aid with proper flex cable connection, a locator line has been added near the end of the palm-rest flex cable. When replacing the palm-rest flex cable, press the cable into the connector until the line aligns with the system board and hold it steady while you snap the ZIF connector down. (The locator line may reappear after the connector is closed, which should not indicate a problem with the connection.)

Back to Contents Page