While bracing the keyboard upright on its left end, connect the
keyboard cable to the keyboard interface connector on the system
board.
NOTICE: Position the keyboard/track-stick flex cable so that it is not pinched
when you replace the keyboard in the bottom case.
Insert the metal tabs at the left end of the keyboard under the edge of
the bottom case, and fit the keyboard into place.
Check that the keyboard is correctly installed. The keys should be flush
with the left and right surfaces of the palm rest.
Turn the computer over and reinstall the four M2.5 x 20-mm screws.
For extra stability, you can open the computer slightly and brace the
keyboard under each screw as you install the screw.