Jumpers: SONY CD-RW CRX216E 48X CD-RW Drive User's Guide
Back
to Contents Page
Jumpers: SONY CD-RW CRX216E 48X CD-RW Drive User's Guide
Jumper Locations | Jumper
Settings
Set the jumpers on the back of the drive in accordance with the configuration
of your computer system. The jumpers are preset to the CSEL position.
Jumper Setting Description
Master (MA)
Configures the drive as the master.
Set the CD-RW drive as master if the drive is the only device connected
to the IDE card.
Slave (SL)
Configures the drive as the slave.
Set the CD-RW drive as slave if the drive is daisy-chained with a hard-disk
drive on an IDE card.
CSEL (CS)
Configures the drive by using host interface signal CSEL
(Cable Select).
This is the default setting for Dell desktop and workstation systems.
NOTE: Do not use any other jumper setting.
Please read all restrictions and disclaimers.
Back to Contents Page
