Dell performs the installation and setup on any DVD+R/RW drive
that is shipped as part of a system, including loading the appropriate device
drivers when the operating system is installed. The drive is ready for use when
you receive your system. No further installation or configuration is necessary.
Installing the Drive
Drives Purchased Separately as Customer Kits
Installing the DVD+R/RW drive
Remove the DVD+R/RW drive from its packaging.
Turn off the power to your computer and unplug the power cord.
Remove the cover, face plate and clips or brackets used to secure internal
devices. Please refer to your system documentation for more information.
If you are replacing an existing drive, determine whether your old drive
has an IDE interface, then disconnect and remove the old drive from the
system.
Verify that the jumper is set to CSEL (Cable Select) The jumper is located
at the Jumper Connector.
Locate the secondary IDE connector on the system motherboard.
Using the IDE cable provided with the system, connect the drive�s IDE
Interface Connector to the existing secondary IDE connector.
Connect the audio cable between the DVD+R/RW drive�s Analog Audio
Connector and the sound card or the system motherboard (if necessary).
Connect the power cable to the Power Connector of the DVD+R/RW drive.
Close your system case by re-installing the cover and face plate (which
were removed in step 3). Please refer to your system documentation for more
information.
Install the Roxio Easy CD Creator Basic software package that is provided
with the DVD+R/RW drive.
Device Drivers
When using Windows 2000 Windows XP, no special device driver is
required.
