This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions:
This device may not cause harmful interference, and
This device must accept any interference received, including interference
that may cause undesired operation.
Trade Name:
NEC
Model No.:
NR-7900A
Responsible Party:
NEC TECHNOLOGIES, Inc.
Attention:
Mr. Amin Fatani, Senior Engineer
Compliance Engineering Dept.
Equipment Classification:
FCC Class B peripheral device (JBP)
Type of Product (EUT):
Internal IDE CD-R/RW Drive
Manufacturer:
NEC Corporation
Address:
7-1, Shiba Go-chome, Minato-ku
Tokyo, 108-8011 Japan
We hereby declare that the equipment bearing the trade and model number
specified above was tested conforming to the applicable FCC Rules under
the most accurate measurement standards possible, and that all the necessary
steps have been taken and are in force to assure that production units
of the same equipment will continue to comply with the Commission's requirements.
Applicable Regulatory Requirements
The NR-7900A CD-R/RW Drive has been certified by the following regulatory
agencies:
UL/C-UL, TUV, CB, NEMKO, DHHS, FCC, CE, C-tick, MIC (EMC for Korea),
BSMI
WARNING: To prevent fire or shock hazard, do not expose
the unit to rain or moisture.
To avoid electrical shock, do not open the cabinet. Refer servicing
to qualified personnel only.
CAUTION: As the laser beam in this NR-7900A is harmful
to the eyes, do not attempt to disassemble the cabinet. Refer servicing
to qualified personnel only.
The use of optical instruments with this product will increase eye
hazard.
The use of controls or adjustments or performance of procedures other
than those specified herein may result in hazardous radiation.
WARNING: For the customers in U.S.A.:
You are cautioned that any changes or modifications not expressly approved
in this manual could void your authority to operate this equipment.
NOTE: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
This CD-R/RW drive unit is classified as a CLASS 1 LASER PRODUCT.
The CLASS 1 LASER PRODUCT label is located at the top of the enclosure.
