Jumpers: Hitachi DK23CA Disk Drive User's Guide
Back
To Contents Page
Jumpers: Hitachi DK23CA-30/20/10/60
Disk Drive User's Guide
Jumper
Settings
Jumper
Locations
Jumper
settings
When the
drive is connected to the host bus, Device address setting is necessary
to configure a drive as Device 0(Master) or Device 1(Slave). The device
address setting is established between drives on the interface connector
by using jumper 0-2 (pin #A, B, D). The Device 0(Master) is assigned to
drive address 0, and the Device 1(Slave) is assigned to drive address 1.
Recommended
type of jumper socket
Vender:
IRISO ELECTRONICS CO., LTD. Vender Part Number: 9721HJ-GF or Equivalent
Jumper
locations
(1) Device
0 : If all of pins A, B, D is open, the drive is Device 0 (Master
or single).
|
interface
connector
|
|
PCB(Printed
Circuit Board)
|
(View
from Interface Connector)
(2)
Device 1 : If jumper position A-B(marked) is used, the drive is Device
1 (Slave).
|
interface
connector
|
|
PCB(Printed
Circuit Board)
|
(View
from Interface Connector)
(3)
CSEL Selection: If jumper position A-C(marked) is used, the device address
setting is determined by the condition of CSEL signal (Pin #28).
|
interface
connector
|
|
PCB(Printed
Circuit Board)
|
(View
from Interface Connector)
Please read all restrictions
and disclaimers.
Back
To Contents Page
|
