|
 | | |
Setup: Quantum Atlas 10K 36GB SCSI Hard Disk Drive User's Guide
Back
to Contents Page
Setup: Quantum Atlas� 10K 36GB SCSI Hard Disk Drive
User's Guide
Dell Installed Drives
� Customer Kits
Dell Installed Drives
Dell performs the installation and setup on SCSI hard-disk
drives that are shipped as part of a system. The default SCSI ID for a
boot hard-disk drive installed in a Dell system is SCSI ID 0. After
installing the drive, Dell prepares the drive for operation with your operating
system. The drive is ready for use when you receive your system.
Customer Kits
Installation Guidelines
Consult the dell documentation for your
system to determine drive requirements, such as number, type, and physical
size of drives supported.
SCSI ID of the Drive
Default is SCSI ID 0.
Verify that there are no SCSI ID conflicts
with other SCSI devices.
SCSI Interface
The SCSI interface is 68-pin Wide
LVD.
Termination
The Quantum Atlas 10K hard disk
drive cannot be configured to provide bus termination. Therefore, be sure
to properly terminate the SCSI bus on which this drive is installed.
Installing the Drive
The mounting holes on the Quantum
Atlas 10K hard disk drive allow the drive to be mounted in any orientation.
For mounting, #6-32 UNC screws are recommended.
Preparing the Drive for Operation
The Quantum Atlas 10K hard disk
drive is shipped from the manufacturer low-level formatted in 512-byte
sectors. Use the programs provided with the SCSI host adapter card
to prepare the drive for operation.
Back to Contents Page
|
|
|